General Information
NOTICE: Warnings and Cautions appear at appropriate sections throughout this literature. Read them carefully.
WARNING:
Indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION:
Indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate injury. It may also be used to alert against unsafe practices.
CAUTION:
Indicates a situation that may result in equipment or
WARNING
Hazardous Voltage w/
Capacitors!
Disconnect all electric power, including remote disconnects before servicing. Follow proper lockout/ tagout procedures to ensure the power can not be inadvertently energized. Failure to disconnect power before servicing could result in death or serious injury. Discharge all capacitors before servicing. Verify with an appropriate voltmeter that all capacitors have discharged. Failure to disconnect power and discharge capacitors before servicing could result in death or serious injury.
This power cord accessory can be used to connect a PTAC unit to the building power supply. See Table 1 for a description of available power cord accessory kits.
265 Volt Electrical Supply
The 265 volt model PTAC unit must be permanently connected to the building power supply in accordance with the National Electrical Code. A power cord accessory installed on a 265 volt model PTAC unit can be plugged into a receptacle mounted in the subbase (sold separately).
Subbase accessories provide an enclosure for permanent connection. Instructions provided with the subbase must be carefully followed. It is the responsibility of the installer to ensure that connections are done in accordance with these instructions and all electrical codes.
The correct power cord accessory is determined from Table 1. DO NOT plug this power cord into a wall or oor mounted electrical receptacle and leave the cord exposed. This type of connection is not permitted by the National Electric Code.
Receiving
Upon receipt of the product, inspect the shipping carton for signs of visible damage. Report any damage or shortage to the carrier, and note it on the delivery receipt. Unit must be stored in its original shipping carton in a dry, secure place prior to its installation and use.
230/208 Volt Electrical Supply
A power cord accessory installed on 230/208 volt model PTAC units can be plugged into a receptacle mounted in the wall, oor, or subbase. The correct accessory is determined from Table 1.
All wiring must be in accordance with the NEC and local codes, ordinances and regulations.
