Haier FCD-JTHC80A-III (E), FCD-JTHC100A-III(E) user manual Installation, Safety Precautions

Installation

Connection and Use of Safety Valve:

After switching on the water heater, a little water will drip from the safety valve pressure relief vent due to normal expansion. The vent shall always keep open to the air. Avoid being blocked.

Connect one end of the hose to the safety valve vent and the other end to the sewage drain. The hose can be cut short or extended as necessary. To avoid splash, the hose shall be installed as inclined downward.

Fix the showerhead holder at a suitable place on the wall, and place the showerhead on the holder. After making sure the tank is full of water, connections show no water leakage and power supply complies with requirement, connect the power supply and make trial operation.

Pressure Relief Vent

(Fig.4)(Fig.5)

Attentions in Installation

During installation, adequate space must be reserved for future maintenance and repair. If the water heater is installed within decoration boards, the right board shall be removable to facilitate removing the plastic cover during maintenance.

City water inlet pressure shall not be less than 0.05 Mpa.

Electric water heater shall be installed indoors with ambient temperature above 0 . The pipes shall be collectively laid. Hot water outlet shall not be too far from use points. In case farer than 8 m, hot water pipe shall have a thermal insulation to minimize heat loss.

The mounting wall shall be firm and reliable to support twice the weight of water heater full of water. Non-load bearing walls or air brick walls must have corresponding protective measures like additional support, wall-through screws or back boards.

Electric water heater shall be located in a place easy for use, maintenance and with a floor drainer. In case the tank or pipes leak, nearby or lower facilities shall not be damaged. The installation location shall avoid being above toilet bowl, bathtub, washbasin or doorframe, where will cause a suppressed or unsafe feeling to users.

Power socket for water heater shall be in a dry place free of water splash. (splash- proof box is preferred)

Do not confuse inlet and outlet water pipes. Safety valve shall be installed at designated position with no random modification. The safety valve pressure relief vent shall keep open to the air. Do not block it.

Safety Precautions

	The water heater shall use a.c. 220 V / 50
Check if power meter and wire size are	Hz power supply from a separate socket (no
	multi-purpose socket) and be reliably
consistent with water heater rated current.
	grounded. The power socket shall meet
If necessary, ask experienced qualified
	national standard requirements. Power plug
electricians to check.
	pins shall be cleaned in time to avoid any
	contamination causing accidents like fire.

Do not	use damaged wire, socket or	Power socket for water heater shall be
appliances with loose plug, otherwise		located in a dry place free of water spray.
accidents like electric shock, short circuit		Do not insert or pull the power plug with
and fire	may occur. Make sure power plug	wet hands, for accidents like electric
closely fits with power socket.		shock or injury may happen.

For first use after installation, the tank
must be full of water before connecting the	Please do not point the showerhead
p o w e r . O t h e r w i s e , h e a t i n g e l e m e n t
	towards human body when turning on or
overheat may cause troubles.Children
	off the faucet, avoiding to be scalded by a
taking shower must be attended by adults.
	small stream of hot water.

	Damaged power cord must be replaced
In winter in cold regions, for long-term out-	by after-service technicians with special
	cable (factory provided). Other persons
of-use, please lift the safety valve handle to
	shall not dismantle or repair. In addition,
empty the water, avoiding ice formation
	do not place flammable matters nearby
damaging the water heater.
	the water heater.

The product adopts Haier Safe Care patented technology. In normal installation, even in severe case that ground wire is live due to wrong connection, the product Safe Care technology can filter and efficiently ensure your safety. However, whenever your feel a sensory current, please pull out the power plug and notify local after-service men in time. Do not dismantle by yourself.

Symbol Denotation

Do not proceed! Wrong operation may cause fatal injury or death.

Do follow the instructions! Wrong operation may cause human injury or house property loss.