Haier GDZ3.5-61, GDZ5.0-61 6. Do not take the laundry out until drying process is done, 7. Unplug the power cord, 8. Clean filters, 5. Dry time settings, 4. Set heat selector knob to select Strong dry or Soft dry level., ' ' ' ' ' '

Using Method

6. Do not take the laundry out until drying process is done

The last 20 minutes of hot air drying is cooling

to reduce the temperature of laundry inside

the drum.

To take the laundry out during drying, please

run cooling operation first since the temperature

inside the drum must be high.

Static electricity, due to friction, will be

generated on clothes made of chemical fibre

after dried. You can feel it when taking them out,

which is normal and shall not to be worried about.

7. Unplug the power cord

Please hold plug to unplug power cord from

a receptacle. Do not pull electrical wire directly

to prevent internal breakage or bad connection.

8. Clean filters

Clean the lint filter after every load and before each use. A clean filter ensures

sufficient drying. A layer of lint on the filter reduces airflow through the clothes

and prolongs drying time

5. Dry time settings

Please refer to page 10 Control panel and its functions

and page 12 Dry Capacity ¡¤Dry Time Reference Table .

' '

4. Set heat selector knob to select Strong

dry or Soft dry level.

' ' '

' ' Strong dry level for large quantity and low room temperature.

' ' Soft dry for non heat-resistant clothes.

Soft

Heat selector knob

Select dry program according to clothes materials and

quantity, turn the timer knob to relative position. The

dryer starts running.

Strong

Caution: Dry timing knob cursor

shouldn't be set at the blank area,

as indicated in the right figure.

Refer to the instructions on page 13.

Do not

point the

cursor to

blank

OFF

Air dryingAir drying

CoolingCooling

Do not point the

cursor to blank.

2020

4040

6060

8080

120120

100100

140140

160160

180180

200200

2020

4040

6060

220220

Please refer to page 10 ' Control panel and its functions' .