Haier HDW101SS, HDW101WH manual Turning on the Appliance, Wash Cycle Adjustment Buttons

Turning on the Appliance

Starting a wash cycle￿

-Make sure that the plug for the appliance is inserted into the wall socket.

-Make sure that the water supply is turned on to full pressure.

-Load the dishwasher (see the section entitled, "Loading the Dishwasher" on page 4).

-Pour in the detergent (see the section entitled, "Detergent and Rinse Aid" on page 3).

-Turn the knob located on the right of the control panel in clockwise direction until the number or symbol for the cycle setting is aligned with the reference mark (see the section entitled, "Wash Cycle Table" on page 7).

-Press the ON-OFF button, and the ON-OFF light will turn on. At this point, the wash cycle will begin.

If you forget to load some of the dishes￿

The wash cycle can be interrupted by pressing the ON-OFF button. You can then load additional dishes and turn the appli- ance back on. The cycle will start where it left off.

At the end of the wash cycle￿

When the knob stops turning and is aligned with a STOP mark (see figure), the cycle has finished. Turn off the appliance using the ON-OFF button, turn off the water supply and open the door of the dishwasher.

Wait a few minutes before unloading the dishwasher to avoid handling the dishes and utensils while they are still hot and more susceptible to breakage. They will also dry better.

Cancelling or modifying a wash cycle setting￿

A cycle that is underway can only be modified if it has been running for a short time. Otherwise, the detergent may have al- ready been used, and the appliance may have already drained the wash water. If this is the case, the detergent dispenser must be refilled (see the paragraph entitled, "Loading the Detergent" on page 3).

Press the ON-OFF button, and the ON light will turn off. Rotate the knob in clockwise direction to the desired cycle setting (see the section entitled: Starting a wash cycle￿?F. Then, turn the dishwasher back on using the ON-OFF button.

Wash Cycle Adjustment Buttons

Eco Button

This button (see "close-up View - Control Panel" on page 1, letter "G" ) is used for normal dirty dishes, pots and pans. It is a standard daily cycle. This button reduces the washing tempera- ture from 60￿=to 50￿I=saving energy costs.

It can be used before setting any of the wash cycles, except for the intensive cycles (if included in the wash cycle table ). Please keep in mind that the amount of detergent should also be cut in half.

Half load Button

This button (see "close-up View - Control Panel" on page 1, letter "H" ) makes it possible to wash dishes using only the up- per rack if there are not enough dishes for a full load. This will allow you to save on water and electricity.

Fast

This button (see "close-up View - Control Panel" on page 1, let- ter "I" ) , when pressed with wash cycle 4 (glassware) make it possible to run the wash cycle at a lower temperature (50￿) and eliminates the drying phase.

.5.GB