INSTALLATION INSTRUCTIONS
Rear venting
If you want to choose the rear venting mode, the exhaust grill at the front of the dryer needs to be replaced with the outlet cover from the back panel of the dryer. Gently open the grill, using a thin tool such as a key. Next, remove the cover from the back panel and clip it into the grill space at the front panel. The exhaust grill is not required when using a flexible hose.
INSTALL THE FLEXIBLE HOSE(optional Flexible hose)
Connect the narrow end of the connector to the dryer duct pipe mouth at the back of the dryer. Then connect the flexible hose to the wide end of the connector. Use the clip to
Flexible connector Outdoor
fasten connection point between the flexible hose and connector (fasten clip with a screwdriver). Extend the flexible hose through the duct hole, make sure the flexible hose is not twisted to allow the air to be vented outside.
Flexible hose
Flexible hose clip
Vent cap
Duct hole diameter 100mm)
Notes: If duct hole is not available at user's home, make sure the flexible hose is vented through a window.
If the dryer is mounted on the wall in the inverted position, you can not use the flexible hose.
The flexible hose should be angled to avoid water running back into the dryer. Ensure a vent cap is fitted when vented outside.
Correct fixing mode:
Fig.1 | Fig.2 | Fig.3 |
|
13
