Haier HP32R Connecting a DTVdigital TV, Connecting a digital audio output, How to connect

Installation

External Equipment Connections

Connecting a DTV(digital TV)

This TV can receive Digital Over-the-air/Cable signals without an external digital set-top box. However, if you do receive Digital signals from a digital set-top box or other digital external device, refer to the figure as shown below.

This TV supports HDCP (High-bandwidth Digital Contents Protection) protocol for Digital Contents (480p,720p,1080i).

How to connect

Use the TV`s COMPONENT , VGA or HDMI jack for video connections, depending on your set-top box connector. Then, make the corresponding audio connections.

How to use

1.Turn on the digital set-top box. (Refer to the owner`s manual for the digital set-top box.)

2.Use INPUT on the remote control to select COMPONENT , VGA or HDMI source.

Signal	COMPONENT	HDMI
480i	Yes	Yes
480p	Yes	Yes
720p	Yes	Yes
1080i	Yes	Yes
1080p	Yes	Yes

HDMI IN	VGA IN					COMPONENT IN	OPTICAL
VGA AUDIO							OUT
	VGA		2	Y	Pb	Pr	L-AUDIO- R
2
1
L-	DVI	- R	1	Y	Pb	Pr	L-AUDIO- R
	AUDIO
HDMI

Connecting a digital audio output

Send the TV`s audio to external audio equipment (stereo system) via the Digital Audio Output (Optical) port.

How to connect

1.Connect one end of an optical cable to the TV Digital Audio(Optical) Output port.

2.Connect the other end of the optical cable to the digital audio (optical) input on the audio equipment.

See the external audio equipment instruction manual for operation.

Note

When connecting with external audio equipments, such as amplifers or speakers, please turn the TV speakers off.

Caution: Do not look into the optical output port. Looking at the laser beam may damage your vision.

Digital Set-top Box

OPTICAL OUT

L-AUDIO- R VIDEO OUT

L-AUDIO- R 1 VIDEO

12 PLASMA TV