Operation of icemaker and cold water supplier
Before using the ice maker and cold water supplier
*Water supply tube installation
*Pressure of the cold water supplied to the automatic ice maker is between 0.15~0.85Mpa.
*The water tube should be cut with necessary length, free from bend. Suggested maximum length of the water tube is approximately 12 meters. The water tube with excessive length may affect the capacity of ice making due to the loss of water pressure.
*The water tube should be away from any heat resource.
*Since the purifier does not function for sterilization of any bacterium, it is strongly recommended that drinking water be used for ice making.
*The water tubes should be installed and tested by professionals.
*When the appliance is put into operation for the first time, keep the Cold Water button pressed every one minute to supply cold water into the tank into the refrigerator/freezer compartment until cold water is supplied. Never press the cold water button for an extended period or the water valve may become excessively warm.
Caution:
Before connecting the appliance with the water supply resource, ensure that the hand of the ice maker is set to position "O".
Home bar (only for HRF-689FF/A series)
A cantilever tabletop of the home bar
Do not cut food on the tabletop to avoid damages caused by sharp edges.
Do not apply excessive weight on the tabletop.
Do not remove inner cover of the home bar.
The home bar will cease operation if the inner
cover is removed.
Ensure that the home bar is out of reach of children.
Accidental fault may cause damages to the
home bar or injuries to children.
Caution: For the sake of energy efficiency and access convenience, the home bar can be used without opening the door of the refrigerator. Close the door of the home bar immediately to avoid losses of cold temperature in the refrigerator compartment.
18 | 15 |
