Defrosting and cleaning
Defrosting
Defrosting is performed automatically.
Defrosted water will flow into a evaporating recipient on the compressor where the defrosted water will evaporate in the heat and circulating air.
Cleaning
The refrigerator should be cleaned regularly to prevent the formation of bad odors.
* Disconnect the power before cleaning the refrigerator.
* Clean the refrigerator with a soft cloth or sponge with mild detergent.
Acid
Detergent Gas
Caution: Do not use a hard brush, steel brush, detergent, gasoline or other solvents, hot water, acid or alkali for cleaning.
* Dry water droplets on surfaces of the refrigerator with a piece of cloth.
Caution: Do not use excessive amounts of water for cleaning the refrigerator. Use a dry cloth to clean the switch and the lamp.
* Always keep the door gasket clean
Operation
Connection of power supply
When appliance is connected to power supply, the intelligent operation and CRUSHED ICE modes are activated automatically with display of actual refrigerating and freezing temperatures. The appliance is equipped with a memory system, which can ensure that latest operation mode is resumed when power is supplied after an interruption.
Setting of operation mode
Suggestion!
Regardless of irrespective fluctuations in ambient temperature, selection of the fuzzy control will guarantee the most efficient and
Either of the following operation modes can be selected.
Fuzzy control: If there is no special requirement, the fuzzy control is recommended.
Press the fuzzy control button, the fuzzy control indicator will illuminate and the refrigerator is then operated automatically. (See section "Functions").
Manual adjustment mode: Press the temperature setting button to set the temperature . (See
section "Functions")
Loading the freezer with food
Wait some time lapse before loading the refrigerator with food when desired temperature value is achieved.
Caution: Some time will be required for the refrigerator to reach the set level after temperature is reset. The length of this period is determined by difference in the existing and set temperatures, the ambient temperature, the frequency with which the door is opened and closed and the amount of food in storage.
26 | 7 |
