COOL,HEAT and DRY operation

Recommendations: Use COOL in summer. Use HEAT in winter

Use DRY in spring, autumn and in damp climate.

Press ON/OFF button, unit starts.

Previous operation status appears on display. (Not Timer setting)

Power indicator on indoor unit lights up.

Press MODE button. For each press, operation mode changes as follows:

AUTO COOL DRY HEAT FAN

Unit will run in operation mode displayed on LCD.

Stop display at your desired mode.

(3) Select temp. setting

Press TEMR button.

Every time the button is pressed, temp. setting increases 1oC

Every time the button is pressed, temp. setting decreases 1oC

Unit will start running to reach the temp. setting on LCD.

Press FAN button. For each press, fan speed changes as follows:

LO MED HI AUTO

COOL operation starts when room

temp. is higher than temp. setting.

Ultra-low air flow

Unit runs at the speed displayed on LCD.

In HEAT mode,warm air will blow out after a short period of time due to cold-draft prevention function.

In DRY mode, when room temperature becomes lower than temp.setting+2oC,unit will run intermittently at LOW speed regardless of FAN setting.

Temp. setting+2oC

Temp. setting

On reaching temp. setting, unit will run in mild DRY mode.

On cooling only unit, heating mode is not available.

Remote controller can memorize each operation status. When starting it next time, just press ON/OFF button and unit will run in previous status.