Operation
(5) Air flow direction adjustment
After operation mode is selected, vertical flap will open automatically according to the mode. Referring to the Fig.
COOL
About 10o 
Up and down (Use remote controller)
Press SWING button, vertical flap will move within the range shown in the Fig. Press SWING button stop it at a fixed position.
About 10o 
COOL About 45o
HEAT About 60o
HEAT
About 60o 
Left and right air flow adjustment (manual)
Move the horizontal blade by a knob on air conditioner to adjust left and right direction referring to Fig.
Cautions:
It is advisable not to keep vertical flap at downward position for a long time in COOL or DRY mode, otherwise, condensate water might occur.
Cautions:
When humidity is high, condensate water might occur at air outlet if all horizontal louvers are adjusted to left or right.
(6) Unit stop
Press ON/OFF button. Only time remains on LCD.
All indicators on indoor unit go out. Vertical flap closes automatically.
Cautions:
Unit won't restart until 3 minutes have elapsed, due to system protection. HEAT mode is not available on cooling only unit.
Hints
As cold air flows downward in COOL mode, adjusting air flow horizontally will be much more helpful for a better air circulation.
As warm air flows upward in HEAT mode, adjusting air flow downward will be much more helpful for a better air circulation.
Be careful not to catch a cold when cold air blows downward.
It is harmful to your health in summer to go frequently in and out of places where temp. difference is above 7oC. Temp. difference of
More than this, unit's load can be reduced and power consumption cut down as well. So, you'd better set a temp. difference of
10
