
English
installing your wine & beverage center
Unpacking Your Wine & Beverage Center
1.Remove all packaging material. This includes the foam base and all adhesive tape holding the wine & beverage center accessories inside and outside.
2.Inspect and remove any remains of packing, tape or printed materials before powering on the wine & beverage center
Leveling Your Wine & Beverage Center
•Your wine & beverage center has four leveling legs which are located in the front and rear corners of your wine & beverage center. After properly placing your wine & beverage center in its final position, you can level your wine & beverage center.
•Leveling legs can be adjusted by turning them clockwise to raise your wine & beverage center or by turning them counterclockwise to lower your wine & beverage center. The wine & beverage center door will close easier when the leveling legs are extended.
Proper Air Circulation
•To assure your wine & beverage center works at the maximum efficiency it was designed for, you should install it in a location where there is proper air circulation, plumbing and electrical connections.
•The following are recommended clearances around the wine & beverage center:
Sides……………2” (50mm) Top....................2” (50mm) Back..................2” (50mm)
•Do not overfill your wine & beverage center for optimal wine & beverage cooling.
Note: If your wine & beverage center has been tilted for any reason, wait 24 hours before plugging it in.
5