Install the water inlet hose
Confirm the water tap
Water tap,not suitable Water tap,suitable
Outlet end surface
>10mm
It is required that the front end shall be longer than 10mm.
The outlet end surface of the tap shall be flat and smooth. If not please file it to avoid leakage.
Connection between the water inlet hose jointer and the water tap
1.Press the lower end of the lock lever and push down the slider. Take off the water inlet hose jointer from the water inlet hose component. See to Figure 1.
2.Loosen the screw till the water tap can be accessed. Put the jointer of the water inlet hose on the tap. See to Figure 2. (If the tap diameter is too large and the jointer can not be set on the water tap, please loosen the four screws and take out the bushing in the jointer. See to the figure3.)
Water inlet pipe jointer
|
|
|
|
|
|
|
|
|
|
|
|
| Slider |
|
|
|
|
|
|
|
|
| Screw | ||
|
|
|
|
|
|
|
|
|
|
|
|
|
| Screwdriver |
|
|
|
|
|
|
|
| Mark label |
|
|
Locking lever |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||||||
Water inlet pipe Figure 1 |
|
|
|
|
|
|
|
|
| Figure 2 | |||||||||||||||
3.Fasten the four screws evenly. See to Figure 4.
bushing
Figure 3
4.Take off the nameplate. Twist the fastening nut as per the indication of the figure. See to Figure 5.
Remarks: Before twisting the fastening nut, the thread is 4mm above the upper surface of the nut. After twisting the fastening nut, the thread is 2mm above the upper surface of the nut. See to Figure 6.
About 4mm before twisting
About below 2mm after twisting
Nut
Figure 4 | Figure 5 | Figure 6 |
6
