Install the lint filter
After opening the package, please take out the lint filter from the document bag, install it to the filter cover of inner tub. See to the figure.
Inner tub | Lint filter |
|
How to change the direction of the drain hose
1.Dismount the back cover of the washing machine. 4.Dismount the protecting cover of the drain outlet at the
2.Lay down the washing machine gently with the front | other side as indicated in Figure 3. | |||||||
side facing the | ground. Use cross screwdriver to 5.Extend the drain hose out of the other side. Fix the drain | |||||||
loosen the eight screws. Take off the bottomplate. | hose onto the cabinet with the drain hose rack. Set the | |||||||
back |
|
|
|
|
| drain hose nut on, and fasten the nut to the direction | ||
|
|
|
|
| ||||
|
|
|
|
| bottom plate |
| indicated in the figure, as per Figure 4. | |
|
|
|
|
|
| |||
|
|
|
|
| drain outlet |
| ||
|
|
|
|
|
|
| ||
front |
|
|
|
|
| |||
|
|
| soft item | protecting | fasten | |||
|
|
|
|
|
| cover |
| |
|
|
|
|
|
|
|
| |
3.Put down the outer drain hose. Twist the drain hose nut counterclockwise to take it off as indicated in Figure 1. Take off the drain hose rack. Put the drain hose into the cabinet as indicated in Figure 2.
Figure 3 | Figure 4 |
6.Install the protecting cover of the drain outlet to the other side, as indicated in Figure 5.
Loosen
| Outer |
| drain hose |
Drain hose nut | Drain hose rack drain hose nut |
| |
Figure 1 | Figure 2 |
Figure 5
7.Install the bottom plate (method the same as stated above). Lift up the washing
machine gently.
Usage of the drain hose
The drain hose shall drain smoothly 1.The height of the drain hose shall be
less than 10cm, or the drainage will not be smooth, and cost such long time that
the machine may stop at mid way.
2.Do not ramp or press the drain hose.
3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.
4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.
