Haier HWM90DD manual Trouble Shooting, Washer does not operate, Problems with water

TROUBLE SHOOTING

Washer does not operate:

Check if unit is plugged in. The plug may have come loose.

Check if the electrical wall receptacle is of proper voltage.

Check if the circuit breaker needs to be reset or if the fuse need to be replaced.

Check if the washer is overloaded :load may need to be re-balanced and clothes may need to be redistributed.

Check if the lid is open. You may have to close the lid properly.

The washer pauses in some cycles. This is normal in delicate or hand-wash cycle which has short period of time. You will not hear washer operation for a short period of time . When the soak time is over, it will start automatically.

Problems with water:

Not enough water coming out: Water faucet may need to be turned on fully water . Hoses may be tangled or wrinkled up. Straighten out hoses. Check water level selection, it may need to be readjusted.

Water temperature is incorrect: Check your water heater temperature. Hot water needs to be at a temperature of at least 120 F-140 F(49 C -60 C).Check to make sure the inlet hoses are properly connected. (E.g. Hot to hot & cold to cold)

Water leaks: This is due to not properly installing drain hose or

fill hoses. Your home drain may be clogged . You may need to tighten hoses, check the plumbing or call a plumber.

Water will not drain: This is due to not installing your drain hose properly. Check theposition of the drain hose. In order to drain properly, make sure that top of drain outlet is less than 5 ft. (1.5 m) above the floor.

Washer is making noise:

Washer may need to be reinstalled. (Check washer installation section)

12