REMOTE CONTROL
1
2
3
4
5
6
7
8
9
| 1. | Remote Control Transmitter | ||||||||
10 | 2. | Power Button | ||||||||
| ||||||||||
| 3. iPod MENU + Button | |||||||||
11 | 4. | SKIP |
| Button | ||||||
| ||||||||||
| ||||||||||
5. | ENTER Button | |||||||||
| 6. iPod MENU - Button | |||||||||
| 7. | PLAY / PAUSE |
|
|
| Button | ||||
|
|
| ||||||||
|
|
| ||||||||
12 | 8. VIDEO OUT Button | |||||||||
13 | 9. VOLUME | Button | ||||||||
|
|
|
|
|
|
|
|
|
| |
| 10. ROTATE | Button | ||||||||
14 | 11. SKIP |
| Button | |||||||
|
| |||||||||
|
| |||||||||
| 12. MENU Button | |||||||||
| 13. 3D SOUND Button | |||||||||
| 14. VOLUME | Button | ||||||||
Using The Remote Control
The CR2032 lithium battery is already installed in the remote control. Pull out the small mylar insulation tab as shown in the illustration to begin using the remote control.
PULL
To use the remote controller, point the remote control transmitter on the remote control toward the remote control receiver on the front panel of the main unit and press the desired button. The effective range of the remote controller is approximately 20 feet. Please note that bright sunlight or artificial light may interfere with the proper operation of the remote control.
Battery Replacement
When the remote operation becomes weak or intermittent, it is time to replace the remote control battery. Pull out the battery holder, remove the old battery and install a new CR2032 battery in the holder as shown in the illustration. Slide the holder back into the remote control.
NOTE: If the battery is installed incorrectly the remote control will not work. | R2 | 03 |
| C | 2 |
•Make sure that you have removed the mlar insulation tab from the remote control.
•Ensure the system is connected to an AC outlet that is always “live”.
7
