Disposal after washing
After using, please clean the lint and foreign materials of the lint filter and overflow filter in time. Otherwise it may influence your using the machine.
Cleaning the overflow filter
Please first pull off the power plug from the receptacle before cleaning.
Cleaning the lint filter
The lint filter must be used during washing.
It must be cleaned in time after each using.
1. Press the elastic piece at upper end of lint filter to release the tab from the filter cover, and pull the lint filter outward to remove it. (See Figure 1).
| Figure 1 |
2. Remove lint |
|
Pull the lower end of lint filter rear cover outward |
|
to disassemble it from the lint filter front cover. | Lint filter rear cover |
Remove lint completely with clear water. (See | |
Figure 2). | Disassemble |
| |
| Assemble |
3. Install lint filter |
|
2.Take off the corrugation pipe. Dismantle the upper part of the corrugation pipe inside the overflow filter ( as indicated in Figure 1).
3.Cleaning the overflow filter Clean the lint around the filter and flush with tap water.
4.Install the overflow filter.
(1).Install the corrugation pipe.
(2).Insert the mounting plate at the bottom of the filter into the valve cover.
(3).Hang up the hook at the left
upper side.
(4).Push the upper part in as 
indicated in Figure 2.
Water level adjusting lever
Corrugation
Pipe
Figure 1
Hook
Figure 2
Lint filter front cover |
Page 4 |
Disposal of the complete unit
Figure 2 |
Cleaning the overflow filter
Too much lint on the overflow filter will influence the normal usage of the machine. Please clean it every two months.
1
Take off the overflow filter.
As indicated in the figure, nip the elastic fixing claw and pull it to the direction of the arrow to 
take it off.
Wipe the complete unit with soft cloth twisted dry.
Wipe with neutral detergent if too dirty
Do not wash it directly by water
Alcohol
Petrol 
Thinner
After washing, dismount the water inlet hose.
Do not store water in the tub for long period. Discharge the water immediately after each using.
Pull off the power plug and hang up the power cord.
Hang up the drain hose.
Wipe off the water drops on the surface and inside the tub with clean soft cloth. 
Open the cover of the wash tub and the inner/outer cover of the spin tub for some time (about one hour), then close them.
12
13
