Haier XPB10-LAP user manual Midway spinning, Washing sequence

Washing sequence

Water-filling selector

Water inlet		Wash timer		Wash selector	Spin timer
entrance	(To set to below 2 minute,			(standard current,	(To set to below 1 minute,
	first set to 5 minute then			strong current)	first set to 2 minute then
	turn it back. It can increase				turn it back. It can increase
	the service life of the timer).				the service life of the timer).
	15		3		5	1
	12		6		4	2
	9				3

Wash

Midway spinning

1.Put the laundries into the spin tub evenly and smoothly.

2.Spin

(1) Put the gland in properly.

Please put in the gland properly even if the laundries quantity is small.

Push Gland

Push

1.Water-filling selector

Set the water inlet selector at the "WASH" side. (Figure 1)

2.Fill the water and add the dissolved washing powder to make the water level reach the preset position. (Figure 2)

Run washing program for some time to stir and dissolve the powder completely.

3.Put in the laundries. If the water quantity is insufficient, please add water.

4.Select the current.

Select the strength of the current according to the laundries. (Figure 3)

5.Select the washing time

Select the washing time according to the laundries. (Figure 4)

6.After washing, Set the "WASH SELECTOR" at "DRAIN" in order to discharge the water. (Figure 5).

WASH SPIN

Figure 1

Figure 2

Figure 3

OFF

15

3 Figure 4

12

6

9

Figure 5

Proper	The laundries	Proper No gland
	are slanting

(2) Close the inner and outer cover of the spin tub.

	Outer cover of
	The spin tub
(3) Spin for 1-2 minutes.	Inner cover of
	The spin tub

3.Run the foam-removing spinning.

(1)Open the outer cover of the spin tub.

(2)Set the water-filling selector control

rod at the "SPIN" side. Fill water for

WASH SPIN

about 1 minute.

If the water quantity filled is too large, the water may flow out from the wash tub side. Please twist the water tap to limit the water filling.

(3) Close the outer cover of the spin tub. Spin for 1-2 minutes.

8 9