Haier XQB50-20 user manual How to change the direction of the drain hose, Usage of the drain hose

Before Using

How to change the direction of the drain hose

1 Loosen the fastening screws of the back cover,unpack the back cover gently, avoiding to break the clip claw.

Figure 1

Back cover

3 Stretch out the drain hose to the right of the frame from the groove. Fasten it in the base frame with the drain hose support, and fasten the screws.Then hang the hook in the drain hose, and hang the drain hose in the hole of the cabinet. (Figure 3)

( Figure 3 )

2 Take the drain hose from the cabinet, make the mouth of it flat a little, dismantle the pothook, loosen the fastening screws, dismantle the drain hose support ,and pull the drain hose into the cabinet from the left of the base.

Figure 2

Drain hose frame

4 Install the back cover. Hang the under side of the back cover on the cabinet firstly, then push the left

,the right tab and the upside into the cabinet. Do not do it strongly, and fasten the screws.

(Figure 4)

Upper tab

Screws

	Make the mouth of th	e	( Figure 2 )
Screws	drain hose flat, take off
	the pothook.

Side tab Lower hook

(Figure 4)

Usage of the drain hose

The drainage shall be smooth with the drain hose. 1.Never let the drain hose exceed 10cm above the ground. If the timeof draining is too long, the washing machine will stop in the midway.

2.Do not step on or press the drain hose.

4.If extra drain hose is needed, please make separate purchase. The inner diameter of the extra hose shall not less than 30mm, and the length shall not exceed 1.5m.

> 30mm

<10cm

<1.5m

3.If the drain hose is too long, cut it at mid point. To make smooth drainage, cut the front end of the hose slantingly.

5.If the extra hose is too long,cut it either at A or at B

AB