Hamilton Beach 1G901 operation manual Blender Operation Quick Start Guide

Blender Safety

IMPORTANT SAFETY INSTRUCTIONS

WARNING – When using electrical appliances, basic safety precautions should be followed, including the following:

• Read all instructions.	• To prevent damage to blender, jar, or cutter
• Plug into a grounded outlet.	assembly, DO NOT move or shake blender
• Do not touch surfaces that may be hot.	while in operation. If blending action stops during
	operation, turn blender OFF, remove jar from
Use handles or knobs provided.
	base, remove jar cover, and use a thin rubber
• Extreme caution must be used when moving an
	spatula to push mixture towards cutters.
appliance containing hot oil or other hot liquids.
	• Do not spray the base with a high-pressure
• Do not use appliance for other than intended use.
	spray gun.
• To protect against electrical shock, do not
	• Disconnect power before cleaning or servicing.
immerse cord, plug, or blender base in water
	• To prevent burns from hot liquids splashing out
or any other liquid.
	of the jar, always remove the filler cap of the
• Close supervision is necessary when any
	container cover before blending hot liquids.
appliance is used by or near children.
	• Do not operate any appliance with a damaged
• The use of accessory attachments not recom-
	cord or plug or after the appliance malfunctions,
mended by Hamilton Beach may cause injuries.
	or is dropped or damaged in any manner.
• To reduce risk of personal injury, unplug cord
	Return appliance to the nearest service facility
from outlet when not in use, and before putting on	for examination, repair, or electrical or
or taking off parts or doing any other servicing of	mechanical adjustment.
the blender.	• If the supply cord of this appliance is damaged,
• Do not let cord hang over edge of table or
	it must be replaced by the manufacturer or its ser-
counter or touch hot surfaces.	vice agent or a similar qualified person. If fitted
• Do not place on or near a hot gas or electric	with a non-rewirable U.K. plug, the 13 amp fuse
burner or in a heated oven.	approved by ASTA to be B.S. 1362 must be used.
• To reduce risk of personal injury and to prevent	If you need a replacement fuse carrier, it must be
damage to blender or jar and cutter assembly,	replaced by the same colour coded carrier with
DO NOT insert utensils into blender jar while	the same markings. Fuse covers and carriers
operating blender, or store utensils in the blender	can be obtained from approved service agents.
jar when it is not in use.	IMPORTANT: If the molded plug is cut off,
• Avoid contacting moving parts.	dispose of it immediately. The plug is not rewirable
	and would cause a shock hazard if inserted into
• Blades are sharp. Handle carefully.
	a socket.
• Inspect jar and cutter assembly daily. Check
	• For a complete operation manual in this
cutter for wear, nicks, or broken blades. Replace
	language, please visit our website at
jar and cutter assembly at least every 12 months.
	www.commercial.hamiltonbeach.com
• Do not defeat the jar pad sensors.
	or call 910-692-2223.

•Do not use outdoors.

•This appliance is intended for short periods of operation, with a rated operating time of 3 minutes.

–SAVE THESE INSTRUCTIONS –

Blender Operation – Quick Start Guide

1.Place the blender on a dry, level surface.

2.Make sure the power switch is in the “off” or O position. Plug the blender into a grounded electrical outlet.

3.Place the jar on the base with ingredients and jar lid in place.

4.Set the controls to your preference.

5.Move the power switch to the “on” or I position.

3