Operation
Operating the Blender
wWARNING
Electrical Shock Hazard
Plug into a grounded outlet.
Do not remove ground.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
Controls
Model 1G901:
•The ON/OFF switch will turn the blender ON for continuous operation at approximately 18,000 RPM, or OFF.
Models 1G908, 1G909, 1G910, 1G918, 1G919:
Two separate switches on the front panel allow you to control the blender for precise blending requirements:
wWARNING
Cut Hazard
Always place cover on jar when blending.
Do not put hands, spoons or other utensils in jar when blending.
Failure to follow these instructions can result in broken bones or cuts.
ON/OFF
Switch HIGH/LOW
Switch
ON/OFF
Switch
Model 1G901 | Models 1G908/1G909 |
•The ON/OFF switch will turn the blender ON for continuous operation or OFF.
•The HIGH.LOW switch allows you to select the following speeds:
Hi – 17,800 RPM Low – 11,500 RPM
• The Pulse switch (Models 1G910, 1G918 and |
1G919) turns on the blender only when the |
switch is pressed. When the switch is released, |
the blender will stop. This will allow you to pre- |
cisely control the operation of the blender. |
3.Plug the blender into an electric outlet.
4.Place the ingredients to be blended into container.
5.Place the container onto the base. Make sure it rests securely on the base.
6.Place the cover and filler cap on the container.
ON/OFF/
Pulse
Switch HIGH/LOW
Switch
Using the blender
Before you use the blender for the first time, wash the container, cover, and cutter unit assembly. Refer to “Cleaning the Blender.” Do not put the cutter unit assembly in the dishwasher.
To operate the blender, proceed as follows:
1.Place the blender on a clean, dry, level surface, and set the ON/OFF switch to OFF.
2.Place cutter unit in the threaded collar, blades up. Slip the gasket OVER the blades and onto the base of the cutter unit. Screw the completed blade assembly onto the container.
7. Set the Hi/Low switch | Models | |
1G910/1G918/1G919 | ||
(except model 1G901) to | ||
| ||
the desired speed. See “Professional Blending | ||
Techniques” for blending tips. |
NOTE: If you want the blender to run for short bursts, press the Pulse switch (on some models). While you are pressing the Pulse switch, the blender will run at the selected speed. Release the Pulse switch to stop the blender.
5