840139600 Ev02.qxd 3/21/06 3:45 PM Page 6
Using Your Electric Kettle (cont.)
1.Remove from power base before filling.
2.Fill the kettle with the desired amount of water. Make sure the kettle has at least 8 ounces (250 ml) of water. Do not fill above the MAX fill line. If filled above the MAX fill line, water will be emitted through the
steam vents at the base of the kettle during the boil cycle.
3.Press and hold button on bottom of lid while inserting notches on lid into tabs on kettle wall. The mesh filter must align with the spout. Make sure that the lid is in place and the kettle or power base is standing on a level surface.
If lid is not in place, auto shut-off will not operate.
4.After filling the kettle with water, place it on the base so that it is correctly engaged.
5.Plug into the outlet and turn on (l).
6.The kettle will switch off (O) automatically when the water has boiled.
7.After use, unplug the kettle and empty.
wWARNING
Burn Hazard
•Do not overfill as boiling water can escape spout.
•Avoid contact with escaping steam.
•Carefully carry unit holding hot water. Use handle only.
•Do not pour toward or over people.
•Allow to cool before removing lid or cleaning unit.
Anti-Scale Mesh Filter
NOTE: Do not remove the
Scale is caused by lime and calcium in hard water. The mesh filter will prevent these suspended particles from being poured out of the kettle. To ensure optimum performance of the filter it should be periodically cleaned. To clean the filter, rinse it under running water and brush with a soft brush. An old, clean toothbrush works well.
If Your Kettle Boils Dry
The heating element is protected by two automatic safety devices. If your kettle is accidentally switched on without being filled with water, or is allowed to boil dry, the kettle will automatically switch off. You should:
•Unplug the kettle and wait about 20 minutes for the element to cool down.
•Refill the kettle, then use as normal and check that the kettle functions correctly.
6 | 7 |
