Optional Features (continued)
Retractable Cord
(not available on all models)
1. Press and hold the Cord Release
Cord | Button while |
Release | pulling cord to |
Button | desired length. |
| Do not unwind |
| cord beyond the |
| tape indicator |
| on the cord. |
2.To store cord, place the iron, sole-
plate down, on ironing board. Unlatch Retractable Cord Handle and wind clockwise.
IMPORTANT! Do not press Cord Release Button while winding cord. Only wind clockwise or the cord may jam. See illustration.
3.If cord jams while winding, push the Cord Release Button to unwind slightly until cord is free. Then slowly start to wind clockwise again.
If Retractable Cord Handle comes off, it is designed to snap back in place.
1. Place pins of handle into slots in reel. |
See illustration. |
Retractable |
Cord Handle |
2.Lift handle up until it snaps in place.
Quick Storage Shield
There is no need to wait for the iron to cool before storing.
Make sure the iron
has been turned off
and unplugged.
Then, place the
Quick Storage
Shield on the iron immediately after ironing.
CAUTION: The soleplate may be hot, so care must be used in placing the Quick Storage Shield on the soleplate.
Caring for Your Iron
Iron
1.The water tank of your iron should be emptied after each use. Turn Temperature Control Dial to Off. Unplug the iron and hold over a sink. Slowly tilt pointed end of iron down over sink. Water will run out of water tank opening.
2.After iron has completely cooled, wrap cord loosely around the iron and store in an upright position. Do not store iron laying flat on soleplate.
Soleplate
1.Never iron over zippers, pins, metal rivets, or snaps, as these may scratch the soleplate.
2.To clean occasional
3.Always store iron upright in the heel rest position.
8
