Hamilton Beach 840101300 Special Instructions, Consumer Safety Information, Before First Use

840101300 ENv02.qxd 5/10/02 11:22 AM Page 2

IMPORTANT SAFEGUARDS

When using your flatiron, basic safety precautions should always be followed, including the following:

READ ALL INSTRUCTIONS BEFORE USING

1.Use iron only for its intended use.

2.To protect against risk of electric shock, do not immerse the iron in water or other liquids.

3.The iron should always be turned to OFF before plugging or unplugging from outlet. Never yank cord to disconnect from outlet; instead, grasp plug and pull to disconnect.

4.Do not allow cord to touch hot surfaces. Let iron cool completely before putting away. Loop cord loosely around iron when storing.

5.Always disconnect iron from electrical outlet when filling with water or emptying and when not in use.

6.Do not operate iron with a damaged cord or if the iron has been dropped or damaged. To avoid the risk of electric shock, do not disassemble the iron. Call our toll-free customer service number for information on examination, repair or electrical or mechanical adjustment. Incorrect reassembly can cause a risk of electric shock when the iron is used.

7.Close supervision is necessary for any appliance being used by or near children. Do not leave iron unattended while connected

or on an ironing board.

8.Burns can occur from touching hot metal parts, hot water, or steam. Use caution when you turn a steam iron upside down–there may be hot water in the reservoir.

SPECIAL INSTRUCTIONS

1.To avoid a circuit overload, do not operate another high wattage appliance on the same circuit.

2.If an extension cord is absolutely necessary, a 10-ampere cord should be used. Cords rated for less amperage may overheat. Care should be taken to arrange the cord so that it cannot be pulled or tripped over.

SAVE THESE INSTRUCTIONS!

Consumer Safety Information

This product is a household-type iron.

This appliance is equipped with a polarized plug. This type of plug has one blade wider than the other. The plug will fit into an electrical outlet only one way. This is a safety feature intended to help reduce the risk of electrical shock. If you are unable to insert the plug into the outlet, try reversing the plug. If the plug should still fail to fit, contact a qualified electrician to replace the obsolete outlet. Do not attempt to defeat the safety purpose of the polarized plug by modi- fying the plug in any way.

Use the iron on an ironing board. Ironing on any other surface may damage that surface.

Before First Use

•Steam vents should be cleaned before first use. See the “Self-Clean” section on page 6 for more information.

•Many irons spit or sputter during the first few uses with tap water. This happens as the steam chamber becomes conditioned. This will stop after a few uses.

•During first use of the iron, it may appear to smoke. This will stop and does not indicate a defect or hazard.

To Dry Iron

1.Plug iron into outlet.

2.Set Adjustable Steam Switch to 0 (the Dry Iron position).

3.Turn Temperature Control Dial to desired temperature. Allow two minutes for iron to reach desired temperature.

4.To turn iron Off, turn Temperature Control Dial to Off and unplug iron.

2 3