Hamilton Beach Bar Blender Blender Operation - Quick Start Guide, Important Safety Instructions

Blender Safety

IMPORTANT SAFETY INSTRUCTIONS

WARNING –When using electrical appliances, basic safety precautions should be followed, including

the following:

•Read all instructions.

•Plug into a grounded outlet.

•Do not touch surfaces that may be hot. Use handles or knobs provided.

•Extreme caution must be used when moving an appliance containing hot oil or other hot liquids.

•Do not use appliance for other than intended use.

•To protect against electrical shock, do not immerse cord, plug, or blender base in water or any other liquid.

•Close supervision is necessary when any appliance is used by or near children.

•The use of accessory attachments not recom- mended by Hamilton Beach may cause injuries.

•To reduce risk of personal injury, unplug cord from outlet when not in use, and before putting on or taking off parts or doing any other servicing of the blender.

•Do not let cord hang over edge of table or counter or touch hot surfaces.

•Do not place on or near a hot gas or electric burner or in a heated oven.

•To reduce risk of personal injury and to prevent damage to blender or jar and cutter assembly, DO NOT insert utensils into blender jar while operating blender, or store utensils in the blender jar when it is not in use.

•Avoid contacting moving parts.

•Blades are sharp. Handle carefully.

•Inspect jar and cutter assembly daily. Check cut- ter for wear, nicks, or broken blades. Replace jar and cutter assembly at least every 12 months.

•Do not defeat the jar pad sensors.

•Do not use outdoors.

•This appliance is intended for short periods of operation, with a rated operating time of 3 minutes.

•To prevent damage to blender, jar, or cutter assembly, DO NOT move or shake blender while in operation. If blending action stops during operation, turn blender OFF, remove jar from base, remove jar cover, and use a thin rubber spatula to push mixture towards cutters.

•Do not spray the base with a high-pressure spray gun.

•Disconnect power before cleaning or servicing.

•To prevent burns from hot liquids splashing out of the jar, always remove the filler cap of the contain- er cover before blending hot liquids.

•Do not operate any appliance with a damaged cord or plug or after the appliance malfunctions, or is dropped or damaged in any manner. Return appliance to the nearest service facility for examination, repair, or electrical or mechanical adjustment.

•If the supply cord of this appliance is damaged, it must be replaced by the manufacturer or its service agent or a similar qualified person. If fitted with a non-rewirable U.K. plug, the 13 amp fuse approved by ASTA to be B.S. 1362 must be used. If you need a replacement fuse carrier, it must be replaced by the same colour coded carrier with the same markings. Fuse covers and carriers can be obtained from approved service agents. IMPORTANT: If the molded plug is cut off, dispose of it immediately. The plug is not rewirable and would cause a shock hazard if inserted into a socket.

•For a complete operation manual in this language, please visit our website at www.commercial.hamiltonbeach.com or call 910-692-2223.

–SAVE THESE INSTRUCTIONS –

Blender Operation – Quick Start Guide

1.Place the blender on a dry, level surface.

2.Make sure the power switch is in the “off” or O position. Plug the blender into a grounded electrical outlet.

3.Place the jar on the base with ingredients and jar lid in place.

4.Set the controls to your preference.

5.Move the power switch to the “on” or I position.

3