INSTALLATION

STOP! PLEASE READ CAREFULLY.

CAST COMPONENTS ARE VERY FRAGILE. USE EXTREME CARE WHEN HANDLING.

WARNING

DO NOT LIFT OR PUSH THE UNIT FROM THE ASHLIP, LEFT SIDE CAST or RIGHT SIDE CAST.

THE CASTING WILL CHIP OR BREAK.

INSTALLING YOUR INSERT

Your insert is very heavy and will require two or three people to move it into position.

1)Remove the Door to make the insert easier to handle. To remove the Door, open fully and lift it up off its hinges.

Refer to the Door Removal section for an important note on installa- tion.

Hinges

Door

2)NOTE: For Masonry installation make sure that the fi rebox is level with the hearth using non-combustible materials and no more than 1/2 to 1 inch of the leveling bolt.

3)Lift the unit up onto the Hearth and slide into the fi replace opening. Be sure to leave the unit out at least 3 to 4 inches in order to make the necessary fl ue connections and to install the faceplate.

Be sure to protect your hearth extension during the installation, ie. with a heavy blanket.

Left Side

Cast

Right Side

Cast

Ashlip

DO NOT LIFT UNIT FROM THESE PARTS.

OPTIONAL FLUE

CONNECTOR KIT

The Straight Flue Adaptor (Part #846-504) shown here, may be used to produce a secure connection between your fl ue connector and the insert collar. Detailed installation instructions are included with the kit.

FLUE CONNECTOR

BRACKET

Package contains: 3 brackets and 6 screws.

These brackets are to be used to hold the fl ue liner (not supplied) to the Insert and keep the connection. The brackets are screwed into the top of the Insert in the pre-punched holes and then screwed into the fl ue liner.

8

Hampton HI300 Wood Cast Insert

Page 8
Image 8
Hampton Direct HI300 installation manual Installing Your Insert, Optional Flue Connector KIT, Flue Connector Bracket