stopper assembly |
height adjuster |
flange |
sealing gasket |
mack gasket |
plastic washer |
mounting nut |
tee |
pivot ball seal |
pivot ball nut |
tailpiece |
horizontal rod |
swivel connector |
Install the Pop-up Drain:
Unscrew the flange from the tee. Place the tee and sealing gasket on top of the sink. From below, install the black mack gasket, plastic washer, and mounting nut to the flange.
Thread the tee to the flange from beneath the sink. The tee must be turned so that it faces the faucet. When satisfied with the orientation, tighten the mount- ing nut.
Sit the stopper assembly in the drain.
Install the horizontal rod so that the end goes through the loop in the bottom of the stopper height adjuster.
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the horizon- tal rod. Attach the swivel connector to the end of the vertical rod. Position the vertical rod as desired, and tighten it with a small,
Test the drain for function. If necessary, reposition the swivel connector.
User Instructions
Pivot the handle up to turn the water on, down to turn it off. Pivot the handle to the right for cooler water, to the left for warmer water.
4
