Installation
Position the faucet and sealing ring in place on the mounting surface.
From below the mounting surface, install the friction washer, metal washer and mounting nut. Tighten the mounting nut by hand. Tighten the tensioning screws.
Install the pull rod. | pull rod |
sealing ring
friction washer metal washer
mounting nut 
tensioning screw 
Connect the supply hoses to the stops with 3/8” compression fittings (not included). Use two wrenches, as shown in the diagram, to keep the supply hoses from twisting or becoming loosened from the faucet.
Install the
Turn on the water. Check all connections for leaks.
Reset the high temperature limit stop, if desired.
