Install the Pop-up Drain
Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
Unscrew the tailpiece from the tee. Wrap the threads with plumbers’ thread tape and replace.
plunger
height adjuster
flange
Install the white, flexible sealing gasket to the flange. Place it in the sink outlet.
From under the sink, install the black mack
gasket, white friction ring and retainer nut pull rod to the flange. Do not tighten the nut against
the bottom of the sink at this time.
Thread the tee and tailpiece to the flange. The pivot must face the faucet. If neces- sary, turn the drain assembly.
Tighten the retainer nut.
sealing gasket
mack gasket friction ring
retainer nut
tee
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes through the loop in the bottom of the height adjuster.
pivot ball nut
tailpiece
horizontal rod
Install and hand tighten the pivot ball nut. | swivel connector |
Attach the swivel connector to the end of | |
the horizontal rod. |
|
Attach the swivel connector to the end of the pull rod. Position as desired and tighten with a small, flathead screwdriver.