Installation notes
•Flush the hot and cold supplies thoroughly before installing the faucet. Damage to the faucet caused by debris is not covered under the warranty.
•The hot and cold supplies should be of equal pressure.
•The faucet should not be used with a con- tinuous flow water heater.
•Do not install the faucet on a sink with a raised edge.
•Strong light sources should not shine directly on the sensor window of the faucet.
•The faucet should only be used with the battery pack or power pack supplied by Hansgrohe. Do not attempt to use any other battery pack or power pack.
•Models 32211 / 32213 require a 110 V electrical outlet installed by a licensed electrician. All applicable local codes must be followed.
•The faucet incorporates automatic range adjustment
•The distance between the switch on/off point to the faucet is approx. 6 1/4” - 8” under normal conditions. The detection area may be less for dark,
•If the sink is very small or highly reflective, follow the range reduc- tion instructions on page 12. When the faucet is in reduced range mode, the LED in the sensor window will flash while the faucet is not in use.
•Drops of water or condensation on the sen- sor window may cause the faucet to run.
•If the LED in the sensor window flashes while the faucet is in use, the battery is low, but the faucet may still be used. If the LED stays on, the faucet will not run, and the battery must be changed.
•If the power to the outlet or to the building fails, the 110 V version of the faucet will not run.
•The spray pattern will be unattractive im- mediately after installation or service, due to air in the faucet. After the faucet is used 10 - 15 times, the spray pattern will clear.
