Preparation for Installation:
Turn the water supplies off before removing the old faucet.
Flush the supply lines of debris before beginning installation. Damage to the cartridge caused by debris is not covered under the Hansgrohe limited lifetime warranty.
Install the faucet:
Position the faucet and sealing ring on top of the mounting surface. From beneath, install the plastic washer, slide washer and metal washer. Thread on the collar nut loosely.
If the total thickness of the mounting surface is greater than 1 3/8”, omit the plastic washer.
Inspect the placement of the faucet. Reposition if necessary.
The spout should swivel equally to the right and to the left. If it appears to swivel more to one side than to the other, pivot the faucet body until the swivel is even.
When you are satisfied that everything is oriented properly, finish tightening the collar nut. Tighten the tensioning screws.
