Page 6SKU 41921 for technical questions, please call 1-800-444-3353.
completing AssemblywArning: Unplug the machine before any assembly or adjustment.
Attaching the carrying Handles
Locate the two carrying handles (349), and their hardware, Screws (327).
Attach the handles to the top of the machine firmly using the screws.
installing the table extensions
With the roller up, place each table extension bracket (157) onto the table (125) and attach using
two cap screws (164). Be sure the bracket assemblies are firmly attached, but are able to rotate
up for storage.
Adjust each table extension so that a workpiece supported by the roller is level and in the same
plane with the table. Do this by adjusting the cap
screws (1) in or out as required. See Figure 2. Check
the adjustment by placing a straight edge at least
24” long through the machine, and resting on the
table and both extension rollers. When the extension
is properly adjusted, lock the cap screws in place
with the lock nuts (2).
setting the cutting depth
Place the Table Adjustment Handle (150) over the square-ended Control Screw (130) which pro-
trudes through the top of the machine.
Turn the Table Adjustment Handle to raise or lower the Table to the desired cutting thickness.
Read the cutting depth on the scale on the right of the machine.
Remove the Table Adjustment Handle before operating.
Operating the power switchThe power switch is on the lower right front of the machine.
The Safety Switch Cover must be in place to operate the Power
Switch. You can remove the Cover and store it in a safe place
to prevent unauthorized use.
Press the Switch UP to turn
the machine ON, and DOWN
to turn it OFF.
integral circuit breakerThe circuit breaker trips if the
amp draw exceeds 10 A., pre-
venting motor burn out if the
planer jams, or if there is a
power surge.
To reset, correct the error
condition and press the button
back in.
1.
2.
1.
2.
1.
2.
3.
4.
1.
2.
3.
1.
2.