AIR LINE CONNECTION
NOTE:
For additional references to the parts listed in the following pages,
refer to the Assembly Diagram at the end of this manual.
Die
Grinder
For best service you should incorporate an oiler, regulator, and inline filter, as shown in the diagram above. Hoses, couplers, oilers, regulators, and filters are all available at Harbor Freight Tools.
1.You will need to prepare a 1/4” air connector (not included) to connect to the Inlet (10) on the Die Grinder. First, wrap the 1/4” air connector with pipe thread seal tape before threading it into the Inlet (10). Connect the 3/8” ID Air Source Hose to a quick connect coupler (not included), and then to the Die Grinder.
Note: If you are not using an automatic oiler system, before operation, add a few drops of Pneumatic Tool Oil to the airline connection. Add a few drops more after each hour of continual use.
2.Set the air pressure on the regulator to 90 PSI. Do not exceed the maximum air pressure of 90 PSI.
3.Check the air connection for leaks. Disconnect from the air source.
SKU 33171 | For technical questions, please call | Page 6 |
