Tool Post Adjustment
Loosen the lever shown in (B) of figure 11, the adjust the tool post position. Once the adjustment is made,
(A) with the allen wrench provided.
Automatic Feeding
Adjust the feeding direction selector to the direction you desire. Press down the handle
(A)in figure 12, and continue with the automatic feeding procedure. When feeding, never try to change the feeding direction.
Threading
Select the feeding direction selector to the thread direction desired. Then press down handle (A) in figure 12 by matching the right calibrations on the thread dial indicator (B) and continue with the automatic threading procedure. When threading, never try to change the direction.
Operation
1.Use the chuck to hold the workpiece firmly (figure 13 below). Then, use the rolling center to fix the other end. If you change the rolling center to drilling chuck you start your drillingimmediately.
2.Use the chuck to hold the workpiece firmly and cutter to start lathe’s face cutting (figure 14). The edge of the cutter must be at the same height as the center.
SKU #33684 | Page 9 |