![](/images/new-backgrounds/1331777/33177717x1.webp)
2.The Spring Clamp (1) can be mounted to the Bracket (7) at any of the three holes located at the end of the Spring Clamp (1). Decide on the angle to attach the Spring Clamp (1) to the Bracket (7) - see Figure 2. Thread in Phillips Head Bolt (5) through the Bracket (7) and into the Spring Clamp (1). If the Phillips Head Bolt (5) does not thread in tightly, you may have to add several washers (not included) to obtain a tight fit.
3.The Clamp Light has a Handle (2), which should be mounted to the grommet in the top of the Clamp Light by using a Knob (3) - see Figure 3.
Figure 2
Knob (3)
Knob (3)
Bracket (7)
Figure 3
Handle (2)
Wing Knob (8)
Spring Clamp (1)
4.The Bracket (7) is held in place by two Knobs (3). To rotate the Clamp Light in place, loosen the Knobs (3) and move the Clamp Light to the desired position. Tighten Knobs (3).
Bulb Replacement
1.Make certain that the product is OFF and unplugged. With leather gloves on, squeeze and remove the Grid from the front of the Clamp Light.
2.Remove the Bolt from the top of the Clamp
3.Pull out the Lens from the front of the Clamp Light.
4.Make certain that the Halogen Bulb has had sufficient time to cool. Gently pull out the Halogen Bulb.
5.Making certain NOT TO TOUCH the new Halogen Bulb, insert it into the Clamp Light left side first. Oil from your skin will drastically shorten the bulb’s
6.Insert the Phillips Head Bolt (3) and replace the Grid.
SKU 35149 | For technical questions please call | Page |