y fet Sa
Maintenance and Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent SERIOUS injury from TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
Setup
no rati
1.BEFORE EACH USE, inspect the general condition of the tool. Check for:
•leaking, swollen, or cracked battery,
•loose hardware,
•misalignment or binding of parts,
•cracked or broken parts, and
•any other condition that may affect its safe operation.
2.After Use, wipe external surfaces of the tool with clean cloth.
3.Change the battery as needed.
a.Turn the Power Switch off and Unplug the Solar Panel Cable.
b.Unthread the Wing Nut and Bolt Set and remove the Lamp or Solar Panel.
c.Unthread the six screws on the back of the unit and remove the back cover.
d.Remove the old battery and replace with the same type of battery paying attention to the polarity (±) orientation.
e.Replace the back cover and secure with the six screws.
f.Remount the Unit and plug the Solar Panel Cable into the outlet.
g.Keep the Power Switch off and allow the battery to charge for 8 hours of full sunlight.
h.Turn on the Power Switch.
Ope
ec
Maintenan
Troubleshooting
Problem |
| Possible Causes |
| Likely Solutions |
Light won’t | 1. | Power is not on. | 1. | Check that Power Switch is set to ON. |
turn on. | 2. | Cable connection is loose. | 2. | Plug in firmly at back of Battery Housing. |
3.Battery pack not fully charged. 3. Keep solar panel clean. Allow to charge in full sunlight for 8 hours with the Power Switch OFF.
Light turns on | Light is positioned in | Move light to a location that is lit during the day. | ||
during day. | a dark location. |
|
| |
Light flashes | 1. | Low battery. | 1. | With Switch set to “OFF”, allow to charge in full |
on and off with |
|
|
| sunlight for 8 hours before further use. |
clicking sounds. | 2. | Battery needs replacing. | 2. | Replace battery pack. |
Light stays | Frequent changes in | Check sensing area for possible heat sources | ||
bright. | heat being detected. | such as air vents, vehicles or objects in wind. | ||
|
|
| Reposition the Motion Detector Light if needed. | |
Light brightens | 1. | Changes in heat are being | 1. | Check sensing area for possible heat sources |
and darkens |
| detected from a fixed heat |
| such as air vents, vehicles or objects in wind. |
continuously. |
| source or moving object. |
| Reposition the Motion Detector Light. |
| 2. | Sudden temperature change | 2. | Turn Power Switch “OFF” until storm passes. |
|
| due to storms or high winds. |
| Mount in a sheltered location. |
Follow all safety precautions whenever diagnosing or servicing the tool.
Disconnect Battery Pack and Charger power supply before service.
Page 6 | For technical questions, please call | Item 69644 |
