Installing the Drive Belts
SAFETY
1.Undo the Belt Tension Locking Knobs (18A) on both sides of the head. Turn the Belt Tension Lever (19A) clockwise to bring the Motor Pulley (11A) close to the Spindle Pulley allowing the belts to be slipped on with ease.
2.Lubricate the Idler Pivot Shaft (20) and
Idler Pulley (19), with light grease, and install in its mounting between the motor and spindle pulleys.
3.Consult the chart inside the pulley cover
(or the Drill Speed chart in this manual), and install the belts in the positions corresponding to spindle/drill speed required.
4.Turn the Belt Tension Lever (19A) counterclockwise so that tension is applied to the belts (see Head Assembly diagram). Tension is correct when the belts deflect by approximately 1/2″ at their centers of run when using reasonable thumb pressure. Lock the motor in this position with the locking knob.
SETUP
OPERATION
MAINTENANCE
Functions
Page 8 | For technical questions, please call | Item 38142 |
