23.Do not force the workpiece into the Cutting Wheel Blade (8) when cutting. Apply moderate pressure, allowing the Blade to cut without being forced.
24.Turn off the Tile Saw and allow the Cutting Wheel Blade (8) to stop on its own if the Blade is to be backed out of an uncompleted cut.
25.Never attempt to cut more than one tile at a time.
26.Never attempt to cut freehand. Make sure the tile to be cut is pressed firmly against the Cutting Guide (57).
27.Make sure the Table (51) and surrounding area are clear with the exception of the tile to be cut.
28.Keep all electrical connections dry and off the ground.
29.Always arrange a “drip loop” in the Power Cord (34) connecting theTile Saw to a 120 volt, grounded, electrical outlet. A drip loop is that part of the Power Cord below the level of the outlet, or the connector if an extension cord is used, to prevent water from traveling along the Power Cord and coming in contact with the outlet. If the Power Plug or electrical outlet does get wet, do not unplug the Power Cord. Disconnect the fuse or circuit breaker that supplies power to the outlet. Then, un- plug and examine for presence of water in the outlet. (See Figure A.)
TILE SAW
POWER CORD/PLUG
(34)
120VOLT
GROUNDED ELECTRICAL OUTLET
DRIP LOOP | FIGURE A |
SKU 40315 | For technical questions, please call | Page 7 |
