Warning:
1.Read this instruction manual completely before using the Self Centering Doweling Jig.
2.Always wear ANSI approved safety goggles when working with tools and equipment. Wear a full face shield if you are producing wood chips.
3.Keep children out of the work area. When not in use, store this product in a location that is out of reach of children.
4.Keep work area clean. Cluttered areas invite injuries.
5.Observe work area conditions. Do not use tools in damp, wet, or poorly lit locations. Don’t expose to rain. Keep work area well lit.
6.Do not force the tool. It will do the job better and more safely at the rate for which it was intended. Do not use inappropriate attachments in an attempt to exceed the tool’s capacities.
7.Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
8.Stay alert. Watch what you are doing. Use common sense. Do not operate any tool when you are tired.
Direction for Use:
1.Line up the two boards that are to be connected by the dowels. On the side of each board, draw a vertical mark to show where the dowels are to be located (see illustration
below). |
|
|
|
|
| |
Square Edge |
|
|
|
| Top Board | |
|
|
|
| |||
2. Separate the two boards, |
|
|
| |||
and clamp the Doweling Jig |
|
|
|
| ||
over the edge of one of the boards. |
|
| Bottom Board | |||
Align the mark on the board |
|
|
|
| ||
with the desired dowel diameter |
|
|
|
| ||
|
|
|
| |||
(see hole sizes in Guide Block). | Vertical Marks To Show | |||||
Insert appropriate bushings before | ||||||
Dowel Location | ||||||
drilling the dowel hole to the depth |
|
|
|
| ||
desired. The drilled hole will be |
|
|
|
| ||
exactly in the center of the board edge. |
|
|
|
| ||
#41345 | Page 2 |
