ASSEMBLY
Your Tile Cutter is mostly assembled when you receive it. Please complete the assembly as follows.
Install the Bottom Feet.
1.Slide each Bottom Foot (#T) onto the lower corners of the Base (#V). Attach each one with the bolts, nuts, and washers supplied. Tighten the fasteners firmly.
Install the Circle Cutter.
Your tile cutter comes set up for making straight cuts. Whenever you wish to make circle cuts, you must install the circle cutter. Remove the circle cutter when finished.
1.Raise the Handle (#H) and slide the mechanism away from the circle cutter area towards the Buffer Sleeves (#L).
2.Remove the nut and washer from the Pressing Plate (#E), be careful not to lose these parts.
3.Place the circle cutter mechanism onto the Tracks (#M) with the Press Handle (#A) pointed to the right, away from the Buffer Sleeve portion of the tool.Align the drill point of the circle cutter with the center of the hole in the Base.
4.Place the Pressing Plate (#E) under the tracks and circle cutter assembly, with the threaded rod inserted upward through the hole in the base of the circle cutting assembly.
Install the try square.
Depending on the model you purchased, the try square may install with the arm extension of the try square either to the front of the tool, or to the rear. Both versions work equally well. The measuring scales on your tool also may be marked either in millimeters or inches.
1.Position the try square (#U) with the
Figure 1. Foot Assembly.
Figure 2. Hole Cutter Assembly.
OPERATION
The basic cutting operation is accomplished by scoring the tile in the desired location, and break- ing it. This process is similar to scoring and cutting glass.
NOTE: It’s a good idea to make a few practice cuts on your tile before attempting to make finish cuts.
Use a sturdy workbench, or else place the machine on the floor to increase your leverage.
Page 5 SKU # 41711
