Fig 1. Base Bracket

UNPACKING

1.Remove protective crating and materials carefully. In the event of damage in transit, contact Harbor Freight Tools. Be sure you have all small parts accounted for before discarding packing materials.

2.Check to be sure all parts are present. In addition to the planer, you should receive the accessories noted on page 2. You should also receive a crank handle, 2 carrying handles, and 2 table extensions, with their related hardware. If the 4 base brackets are not installed, they should be included, together

with attaching hardware.

INSTALLATION

1.It is important that the machine be located on a solid, level platform. Find a location that has easy access to 110-120 Volt electrical service. Make sure this machine is located in a well lighted and well ventilated area. The floor should be resistant to vibration. There must be adequate room to insert and remove workpieces through the planer.

2.To permanently install the machine, check the platform to be sure it is even and

level. Make any required corrections to the platform. If the base brackets are not attached to each lower corner of the machine, attach them using the supplied

hardware. Mark and drill holes in the platform, and mount the machine using bolts and nuts.

2.If the machine will not be permanently installed, it is advisable to attach it to wooden skids by means of the base brackets. The skids should be solid hard wood at least 1” in thickness and 2” in width. Route these skids along each side of the machine from front to back. Each skid should extend several inches beyond the machine to allow them to be firmly clamped to the work surface before using the machine.

WARNING: Never operate this machine if it is not firmly attached to a work surface. Unattached, the machine may move along the work surface possibly falling over, ejecting the work piece, or creating other hazards which can cause serious injury.

ELECTRICAL POWER

This machine requires a 110-120V 60Hz grounded power supply. This power is available in most common household or workshop outlets in the United States. Please observe the following safety precautions.

1.Route the power cord in a way that avoids damage to the cord from other tools or machinery, and isolates the cord from exposure to wet or corrosive conditions.

2.Avoid routing the cord along the floor, walkways, or corridors, where it may cause a tripping hazard.

3.Be sure the outlet is grounded and protected with an appropriate circuit breaker. Check with a qualified electrician if you have any doubts or concerns about your electrical service.

4.If you will use an extension cord, be sure to use a 3-prong, grounded cord. Preferably the cord will be UL approved. Know that long extension cords cause a noticable power drop. It is necessary to use cords of the proper gauge to avoid excessive resistance or power drop within the cord. Please comply with the following table.

Extension Length:

0-50ft.

Use minimum 12 AWG cord

 

50-100ft.

Use minimum 10AWG cord

 

over 100 ft.

Not Recommended

 

 

 

Note: Voltage variations of more than + or - 10% from the specification will result in noticable reduction of service, and may cause damage to the motor.

Page 5 SKU # 41831

Page 5
Image 5
Harbor Freight Tools 41831 operating instructions Unpacking, Installation, Electrical Power