Harbor Freight Tools 45813 UNPACKING, ASSEMBLY AND OPERATING INSTRUCTIONS, IMPORTANT

UNPACKING

When unpacking, check to make sure all the parts shown on the Parts List on page 14

are included. If any parts are missing or broken, please call Harbor Freight Tools at the

number shown on the cover of this manual as soon as possible.

NOTE: For additional information regarding the parts listed in the following pages, refer

to the Assembly Diagram on page 14.

1. CAUTION: Always make sure the Power Cord (part #14) of the Polisher/Waxer is

unplugged from its electrical outlet

to making any adjustments to the tool.

2. Place a clean

Waxing Bonnet (part #28) securely onto the Pad

(part #26). (See Figure D , next page.)

3. NOTE: Prior to waxing/polishing a vehicle, make sure it’s surface has been thor-

oughly cleaned and is free of dust, dirt, oil, grease, etc.

4 . Apply about two tablespoons of wax (not included) evenly on the terry cloth

W axing Bonnet (part #28). Do not apply the w ax directly to the surf ace of the

vehicle. The amount of wax needed will vary according to the size of the vehicle

being waxed. NOTE: Avoid using too much wax. For additional applications of

w ax to the Waxing Bonnet, reduce the amount of w ax. The Waxing Bonnet will not

absorb as much wax in subsequent applications. (See Figure D.)

5 . Plug the Pow er Cord (part #14) of the Polisher/Wax er into an electrical e xtension

cord (not included). Then, plug the extension cord into a grounded, 120 v olt,

electrical outlet. (See Figure D.)

6 . In order to keep the e xtension cord out of the w a y,

7. NOTE: Always start and stop the Polisher/W axer while it is held firmly against the

surf ace of the vehicle. Failure to do so ma y result in the Waxing Bonnet

(part #28) being thrown from the Pad (part #26). (See Figure D .)

8 . Grip the P olisher/Wax er firmly with both hands. Then turn the P o wer Switch

(part #13) to its “ON” position and allo w the P ad (part #26) to rotate to its fullest

speed. (See Figure D.)

9 . Begin applying wax to the vehicle. Apply the wax to all flat surfaces with

SKU 45813 PAGE 10 REV 06/05

Carefully inspect the condition of the accessory before use and check the accessory

continually during use. If any damage is noted, stop immediately and replace the accessory

with an undamaged one. Harbor Freight T ools cannot be held responsible for damage

caused by using a damaged accessory on this tool.