Specifications
Electrical Requirements | 120 V~ / 60 Hz | |
|
| |
Lathe Type | Metal Cutting | |
|
| |
Motor | 3/4 HP | |
|
| |
Motor Speed | 1790 RPM | |
|
| |
Spindle Speed | 120, 320, 420, 620, | |
1130 & 2000 | ||
| ||
Spindle Taper | ||
Spindle Bore | 3/4” | |
Chuck | 3 Jaw | |
Chuck Capacity | 4” | |
Tail Stock Quill Travel | ||
Tail Stock Quill Taper | ||
Tool Post Capacity | 3/4” | |
Swing Over Bed | 9” | |
Distance Between Centers | 20” |
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
Proper lubrication is essential. To be safe, and to become more familiar with the Lathe, disassemble the lathe entirely, then clean and lubricate each part with white lithium grease before first use.
List of contents
Part(s) | Description | Qty |
| 9” X 20” Bench Lathe | 1 |
| 4” | 1 |
| Reverse Jaws For Chuck. | 3 |
| Chuck Wrench | 1 |
| Dead Center Mt#2 | 1 |
| Dead Center Mt#3 | 1 |
| Live Center | 1 |
| 1 | |
| 1 |
Part(s) | Description | Qty |
| 1 | |
| Round Nut Wrench | 1 |
| Tool Post Wrench | 1 |
| Hex Wrenches - 3, 4, 5, 6mm | 1 ea. |
| Drive Belts | 2 |
| Threading Gear Set 28,30, | 1 |
| 36,42,45 & 80T |
|
| Oil Can | 1 |
| Splash Guard | 1 |
| Operators Manual | 1 |
Instructions for putting into use
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before assembling or making any adjustments to the tool.
Note: For additional information regarding the parts listed in the following pages, refer to the Assembly Diagram near the end of this manual.
Mounting
1.Unbolt and remove the Lathe from the crate.
2.The Lathe will need to be mounted to a surface capable of bearing the combined weight of the Lathe and intended workpieces. The surface
SKU 45861 | For technical questions, please call | Page 9 |
