Operation (continued)
Warning!! Always wear ANSI approved impact safety goggles. Wear a full face shield if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when working around metal, wood, and chemical dusts and mists. Always wear ear protection. Ear protection is required for any other persons in the work area.
Warning!! Be aware of flying concrete chips. Keep all spectators clear of the work area.
Warning!! Do not operate this tool if you have back, neck, wrist, or other conditions or injuries that will be aggravated by the severe jerking forces that this tool exerts upon its operator.
Warning!! If the Breaker Hammer ever gets out of your control, immediately release the Switch Knob (87).
Note: Use the weight of the Breaker Hammer to help you break up concrete. Use the tool in the vertical position whenever possible. This tool was intended to break up larger pieces of concrete.
IMPORTANT - READ BEFORE USE
This Breaker Hammer may have decreased performance for a brief period at the beginning of each use. This warmup period lasts approximately
Chipping a Straight Line
1.Use chalk or another suitable writing material and mark you work surface to delineate the area you intend to hammer.
2.Plug in the Breaker Hammer.
3.Grasp the handles firmly with both hands. When you are sure that no people or animals are in the vicinity, and it’s safe to begin, depress the Switch Knob (#87).
4.The Breaker Hammer will begin to break the top layer of concrete. If you push down, it will begin to break the next layer as well.
5.Keep moving the Breaker Hammer along the line you want to section, breaking concrete as you go. If the Breaker Hammer jumps off of the line or section, release the Switch Knob (#87) and reposition the Breaker Hammer.
6.When you are finished, release the Switch Knob (#87) and unplug the Breaker Hammer.
Breaking up Concrete.
1.Place the bit on the center of a piece of concrete.
2.Grasp the handles firmly with both hands. When you are sure that no people or animals are in the vicinity, and it’s safe to begin, depress the Switch Knob (#87).
3.As you break the concrete into big chunks, release the Switch Knob (#87) and move to other large pieces until all of the larger pieces are broken. Do not try to break up smaller pieces with this tool as it is too powerful and aggressive to control on small pieces.
4.When you are finished, release the Switch Knob (#87) and unplug the Breaker Hammer.
REV 12/04
SKU 46935 | For technical questions, please call, | Page 6 |
