Harbor Freight Tools 47404 operating instructions INSPECTION, MAINTENANCE, and Cleaning

INSPECTION, MAINTENANCE, AND CLEANING

NOTE: For additional references to the parts listed below, refer to the Assembly

Diagram on page 12.

1.CAUTION: Always turn the Safety Switch (part #32) to its “OFF” position, unplug the Power Cord/Plug (part #34) from its electrical outlet, and wait until the Sanding Disc (part #14) has completely stopped spinning before performing any inspection, maintenance, or cleaning.

2.BEFORE EACH USE, inspect the general condition of the Disc Sander. Check for loose screws, misalignment or binding of moving parts, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation. If abnormal noise or vibration occurs, have the problem corrected before further use. Do not use damaged equipment.

3.DAILY: Sanding Discs (part #14) must be sharp and clean to perform properly. Depending on materials sanded and frequency of machine use, Sanding Discs become clogged with wood, metal particles, and become dull. Dull Sanding Discs rub the workpiece rather than cut, which results in increased friction, higher temperatures, and a burned workpiece. As often as possible, check the condition of the Sanding Disc and, if necessary, replace a worn Sanding Disc with a new, 10” Pressure Sensitive Adhesive disc. (See “To Attach A Sanding Disc To The

Disc Sander” section in this manual for further information.)

4.DAILY: With a soft brush, cloth, or vacuum, remove all debris from the Disc Sander. Then, use a premium quality, lightweight machine oil to lubricate all moving parts.

PLEASE READ THE FOLLOWING CAREFULLY

THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.

SKU 47404 For technical questions, please call 1-800-444-3353. Page 10