Harbor Freight Tools 54425 Specific Product Warnings and Precautions, Figure a

SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS

1.IMPORTANT CONSUMER INFORMATION: This Air Stapler is equipped with a Contact Trip Trigger. This Trigger mechanism is designed primarily for high volume work where exact placement of the Staple is not critical. By holding the Trigger, the Air Stapler will fire each time the nosepiece contacts the wood. A characteristic of this design is the tendency to “double-fire” if used to shoot one Staple at a time. This can be caused by the recoil produced and lingering finger pressure on the Trigger. To avoid this occurrence, hold the Air Stapler firmly against the wood and give the Trigger one quick squeeze. A single shot Air Stapler, equipped with a sequential Trip Trigger, may be considered if high vol- ume, rapid stapling is not required. This Air Stapler should give the owner long, dependable service. However, failure to understand its operating characteristics, or careless use, can result in property damage or serious personal injury.

2.USE ONLY CLEAN, DRY, REGULATED, COMPRESSED AIR AT BETWEEN 60 TO 115 PSI. Never use oxygen, carbon dioxide, combustible gases, or any other bottled gas as a power source for this tool.

3.NOTE: An air compressor is not provided. You will need an air compressor with a minimum rating of 4 to 6 CFM delivery at 90 PSI.

4.WHEN CONNECTING TO THE AIR SUPPLY: Prior to each use, if an automatic oiler is not used, add two drops of Air Tool Oil (part #95) into the Air Plug

(part #33) of the Air Stapler. Attach the air compressor hose to the Air Plug. Turn on the air compressor, and set the regulator to the recommended 60 to 115 PSI for this tool. (See Figure A.)

PSI AIR REGULATOR

TO		TO
AIR
		AIR
STAPLER
	ADJUST	COMPRESSOR
	FROM
	60 PSI TO 115 PSI

FIGURE A

SKU 54425 PAGE 4