the air inlet hole by tightening the Hydraulic Oil Cap.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Inspect engine and equipment looking for damaged, loose, and missing parts before set up and starting. If any problems are found, do not use equipment until fixed properly.
Start Procedure
Before starting the engine: a. Follow the Set Up Instruc-
tions to prepare the equip- ment. Follow all instructions in the separate engine manu- al provided with the engine.
b. Inspect the equipment and engine.
c. Fill the engine with the prop-
er amount and type of fuel and oil.
d. Read the Equipment Opera- tion section that follows.
Equipment Operation
Note: The Log Splitter can accommodate logs up to 25” long and with no more than a 12” diameter. The maximum diameter applies to most soft to medium types of woods. Maximum diameter of hardwoods may vary de- pending on density of the wood.
1.Chock the wheels before starting the engine or changing the position (verti- cal/horizontal) of the unit.
2.Choose the
3.Check oil, gas and hydraulic fluid levels, and fill as necessary. Start the engine, see manufacturer’s manual for directions.
4.Place a log on the Log Lift (1). Push the RIGHT control lever forward to engage the Log Lift and move the log into cutting position. Do not place the logs directly on the Rail Assembly; it is more safe and efficient to use the
Log Lift - See Figure G.
5.When the Log is in place on the Rail Assembly, pull the lever back and allow the Log Lift to return to the original position.
SKU 56072 | For technical questions, please call | Page 11 |
