designed to be used as matched pairs and should not be mixed.
INTRODUCTION
1.The
ASSEMBLY
1.The unit requires minimal assembly before use.
2.Attach the Angle Steel (21) to the base of the Upright (14) by using Bolts (20), Nuts
(18)and Washers (19). Be sure Angle Steel
(21)are fixed securely to the base as they provide stability and will be used to secure the unit to the floor.
3.Insert the Foot Pedal (5) into the Socket (B28) on the hydraulic jack and secure with the Bolt (10) and Washer (11).
4.Push Circlips (29) into the groove on each retaining Pin (30).
5.Slide the Upper Strut Support (31) over the Upright (14) to the required height and align the two holes in the support with two holes in the Upright. Slide the two Retaining Pins
(30)through the assembly and retain them in position using the
6.Two pairs of shoes (28,28A) are supplied. Choose one pair of shoes and attach them to the upper and lower support bracket by using the socket cap Screw (33), the
(22).The shoes are designed to be used as matched pairs and should not be mixed.
7.The unit must now be fixed securely to the ground in order to ensure the safety of the user. Mounting holes are to be found in the brackets, which allow the unit to be secured by way of masonry bolts or sinking pins (not included) into concrete.
WARNING! Whichever method is used, ensure the unit is adequately fixed and cannot topple.
AIR SUPPLY SET UP
8.Ensure the Air Valve (1) is in the “Off” posi- tion before connecting to the air supply. The Spring Compressor requires 120 PSI to oper- ate at full capacity.
9.WARNING! Ensure air supply is clean and does not exceed 120 PSI.
a.Too high an air pressure and unclean air will shorten the life of the unit due to excessive wear, and may be dangerous causing pos- sible damage and/or personal injury.
b.Drain the air supply tank daily and clean the Air Inlet Filter (A16) weekly.
c.When used, drain air filter at least once a day.
Fig.1
10.For recommended air source and automatic oiler
11.Keep hose away from heat, oil and sharp edges.
12.Check hoses for wear and make certain that all connections are secure.
Read the entire Important Safety Information section at the beginning of this document including all text under subheadings therein before set up or use of this product.
Save these instructions.
SKU 65549 | For technical questions, please call | Page 5 |
