Harbor Freight Tools 65785 manual For TV Only Direct. Entry, Identifying Code

For TV Only (Direct. Entry) Continued

7.Manually turn on the unit to be controlled.

8.Press and hold the Code Search Button until the LED stays on. Release the Code Search Button.

9.Point the Remote at the unit and press the Power Button until the unit turns off.

10.If the unit does not turn off, press the Chan- nel Up Button repeatedly until the unit changes the channel.

11.Once the unit is fully functional, press and release the Mute Button (4) to save and pro- gram the code.

12.Test all other buttons on the Remote to verify they work properly.

13.Please note: When the Remote is set and no keys have been pressed for fifteen sec- onds, the Code Search feature will automati- cally turn off.

IDENTIFYING CODE

1.To program the code into the Remote, first press Code Search Button until the LED Indi- cator turns on. Then release the button.

2.Press and quickly release the correct product key (TV, VCR, etc.) from the row of Devise Select Controls (9). The LED Indicator will blink and remain on.

3.Press the Code Search Button again. Con- tinue to do so until the LED Indicator stays on.

4.To find the first code, enter the numbers (0-9) consecutively. When the LED light flashes, this will set the first code. Repeat until you find the second code and then the third code. You will find each code manually by pressing all ten keys to see which one responds.

5.Please note: When the control is set and no keys have been pressed for fifteen seconds, the Code Search feature will automatically turn off.

DIRECT CODE ENTRY

1.Press and hold the Code Search Button until the LED stays on. Release the Code Search

Button.

REV 09l

2.Press and quickly release the correct product key (TV, VCR, etc.) from the row of Devise Select Controls (9). The LED Indicator will blink and remain on.

3.Enter the corresponding 3-digit code. After a valid code entry the LED Indicator turns off. In case of an invalid code entry, the LED will flash.

4.With the unit (TV, DVD) on, press the Chan- nel Up Button (5). If the TV responds, no further programming is needed. If it does not, try another code listed from your brand.

5.Please Note: Some codes do not offer the

Remote full access so you may difficulties with one code. Try another until one works properly.

6.If the unit does not respond after trying all the codes listed for your brand or if your brand is not listed, do a manual code search by doing the following steps.

7.Manually turn on the unit to be controlled.

8.Press and hold the Code Search Button until the LED stays on. Release the Code Search Button.

9.Press and quickly release the correct product key (TV, VCR, etc.) from the row of Devise Select Controls. The LED will blink off once.

10.Point Remote at unit you wish to control.

11.Press the Power Button (3) repeatedly (it may take up to 300 times) until the device to be controlled changes channel. The LED will blink off with each press of the button.

12.Press and release the Enter Button to install the code.

13.Please note: Most users store their unit codes depending on the device, such as storing TV codes for TV. But you can store codes for other devices. For instance, you may store a DVD code under a cable and store something else under DVD. In order to do this, you must program that device code by direct code entry or search.

Please note: If the device do not have a Channel Up Button and uses Play (VCR only) or Power instead, the code search starts from the currently stored three digits number under that mode.

SKU 65785 For technical questions, please call 1-800-444-3353. Page 4