Maintenance And
Servicing
Procedures not specifically explained in this manual must be performed only by a qualified technician.
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
To prevent serious injury from tool failure:
Do not use damaged equipment. If abnormal noise or vibration occurs, have the problem corrected before further use.
Cleaning, Maintenance, and
Lubrication
1.BEFORE EACH USE, inspect the general condition of the tool. Check
for loose screws, cracked or broken parts, damaged electrical wiring, and any other condition that may affect its safe operation.
2.After Use, clean external surfaces of the tool with clean cloth.
3.
WARNING! If the supply cord of this power tool is damaged, it must be replaced only by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
The manufacturer and/or distributor has provided the parts listandassembly diagram in this manual as a reference tool only. Neither the manufacturer or distributor makes any representation or warranty of any kind to the buyer that he or she is qualified to make any repairs to the product, or that he or she is qualified to replace any parts of the product. In fact, the manufacturer and/or distributor expressly states thatall repairsand parts replacements should be undertaken by certified and licensed technicians, and not by the buyer. The buyer assumes all risk and liabilityarising out of his or her repairs to the original product or replacement parts thereto, or arising out of his or her installation of replacement parts thereto.
Troubleshooting
Problem |
| Possible Causes |
| Possible Solutions |
Heat Gun will not turn | 1. | Power Switch set at “0”. | 1. | Turn Power Switch to “l” or “ll”. |
on. | 2. | No power at outlet. | 2. | Check power at outlet. |
| 3. | Cord not connected. | 3. | Check that cord is plugged in. |
Unsatisfactory results. | 1. | Improper heat setting. | 1. | Adjust heat setting (“l” or “ll”) for |
|
|
|
| correct application. |
SKU 66098 | For technical questions, please call | Page 11 |
