Specifications
Electrical Requirements | 120 V~ / 60 Hz / 13 A |
|
|
Temperature | 1100° F Maximum |
|
|
E179876
Unpacking
When unpacking, check to make sure that the item is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
allow access by children or pets to prevent injury and distraction.
2.Route the power cord along a safe route to reach the work area without creating a tripping hazard or exposing the power cord to possible damage. The power cord must reach the work area with enough extra length to allow free movement while working.
3.Secure loose workpieces using a vise or clamps (not included) to prevent movement while working.
4.There must not be hazardous objects, such as utility lines or foreign objects, nearby that will present a hazard while working.
Operating Instructions
Read the entire Important Safety Information section at the beginning of this manual including all text under subheadings therein before set up or use of this product.
Tool Set Up
To prevent serious injury
from accidental operation:
Turn the Power Switch of the tool to its “OFF” position and unplug the tool from its electrical outlet before performing any inspection, maintenance, or cleaning procedures.
Work Piece and Work Area Set Up
1.Designate a work area that is clean and
General Operating Instructions
1.Plug the Power Cord of the tool into a 120 volt, grounded, electrical outlet.
2.The Switch on this heat gun has three positions. Push the Switch up for the heat setting.
3.Allow the Heat Gun one minute to build up to the heat level.
4.To increase the output temperature; use the Knob (7) to close the Vent Cover (8).
5.The Heat Gun can be set on its Base (35) to treat individual workpieces by hand.
6.
WARNING! To prevent serious injury; always wear thermally insu- lated gloves, rated to at least 1200° F, when working directly with pieces by hand.
7.
CAUTION! To prevent personal injury or property damage; do not
SKU 66098 | For technical questions, please call | Page 9 |
